Land Guard 8ft Galvanized Raised Garden Bed Kit, Raised Garden Boxes Outdoor, Oval Metal Raised Garden Beds for Vegetables, Silver,108 Gallon Capacity(with 10 Connecting rods)

Everything comes in the small19 lb box, and take your time
First thing you should know, is that 19 lb box is all there is, do not make the mistake of looking for a second box. Everything is in the first box..Took about a half hour to install with all the bolts and nuts, and yes, you do have a few left over. It’s best to assemble half of the box at a time, but do not tighten all the nuts down at once, give yourself a little bit of wiggle room.How long gonna last that’s a different story and won’t know for a while.

Very nice looking in my garden
Have redone my entire garden w metal raised beds like this. Only thing I don’t really like is that the “nuts” for the supporting arms are too long, and stick out too far, luckily I have left over nuts that I can use instead for this. Other than that, easy to put together, I did in sections of three panels, and then finished assembly on the spot it sits now. Looks nice, quality parts, quick project. These beds are lightweight galvanized tin like grain bibs, and will last a long time outside. Height is a nice foot tall for good roots on a huge variety of plants, this will be 100% functioning as a bed for peas n beans.

No directions, missing parts.
I must have misread the description because I thought this was 2 feet high, but it’s only 1′. I had wanted it to help keep rabbits out of my green beans, but this isn’t going to be high enough to do that. It’s also not the most attractive planter, but should serve its purpose now that it’s finally put together. The putting together was harder than it needed to be because there are virtually not directions. What the manufacturer seems to think should pass for directions is a printed sheet of paper listing the parts and a drawing of the planter with the parts labeled.Parts were another problem. Mine came with one defective bolt, it had no drive on the top so there was no way to insert a screwdriver in it to screw it in. As it turns out, I didn’t need that bolt because I was also missing several of the cross supports. I ended up using the cross supports on the top and then only had 3 cross supports for the bottom. Since the supports come in two pieces, that means I was missing FOUR of these. How does it happen then this was packaged with four missing pieces? They were tied together in two bundles. with plastic ties, so they are likely made in bunches of a certain amount in each bunch, (should have been ten in each bunch) and the ties on mine were tight with no room for any more, so this was made this way at the factory. They didn’t accidentally fall out. That would have been obvious as the ties would have been loose if some of them had fallen out. Perhaps the manufacturer should include a couple extra parts to accommodate for the odd defective part, and have some quality control so that whoever is putting the bunches of dividers together, counts them properly.I have the planter put together now and it took much longer than it should have, because of the lack of directions and missing and faulty parts. It is not as stable as it should be because of the missing parts, so time will tell how long it will hold together.

Good product
Was east to put together, took approximately 1 hr.All parts were there however some threads were stripped. But, included were extra nuts and screws.Instructions were okay.